Tag: Chastity Device

Home

Blogs

2009.06.22 14:03:43

sweet

Real Stories / Informations → Fitting the Birdlocked


1- In order to ease the wearing, I advise you to lubricate inside the ring and tube as well as the skin with a good quality water-based lubricant before fitting the cage.	-2 Push the two testicles, one by one, through the ring. It is easier to keep the cage tube aside to proceed.

3- You can now pass the penis through the ring and align the cage in its final position, the tube at the top.	4- Pull the tube upward and slide the penis inside it.

5- Place the closing strap around the ring and through the lower silicone stem then adjust it on the closing pin. You can then remove the lubricant with some soapy water, dry it off...and give the keys to your KH!	6- You can now lock you up...

Comment

2009.05.07 10:52:50

sweet

Real Stories / Informations → Comparing the Birdlocked and CB6000 in Pictures

Hello,

I promised to publish a comparaison pictures between the CB6000 and the Birdlocked.

So here they are :

As you see, the tubes are having the same length. Internal diameter of the birdlocked is a bit smaller. There are more venting holes on the birdlocked than on the cb6000. The tube angle is also not the same. The biggest difference, apart the material (silicone for the birdlocked and Polycarbonate for the cb6000) is the "A" ring width, about 3cm flat ring for the birdlocked against 1cm squares section for the cb6000.

Close-up of the tube opening:

CB6000 and the Birdlocked Comparaison, the tube opening